Customer case aboutbord and pillar mining

bord and pillar mining

Bord-and-pillar mining explained Illawarra Mercury

Jun 01, 2017 Bord-and-pillar extraction is the older of the methods, and  The word “bord” is not a misspelling of “board”, but a mining term for an underground space or

get price

Bord and pillar mining Coal and coal mining Te Ara

Bord and pillar mining. This diagram shows the traditional method of bord and pillar mining. Miners extracted coal along roadways or bords, with the coal between the bords acting as pillars holding up the roof. The outer pillars were then mined, leaving the roof to collapse in a controlled way as the miners retreated towards the exit.

get price

Bord & Pillar Method Mining Coal

Bord AND PILLAR MINING METHOD comprises of two phases: development and depillaring. Pillars are formed by driving a series of narrow roads (headings) or galleries in the seam. Percentage of extraction during development is nearly 20% in deep mines and 35% in shallow mines.

get price

Bord-and-pillar mining in inclined orebodies

different bord-and-pillar layouts were designed. These layouts were then evaluated according to dilution, produc-tivity, cost implications, profit and mining flexibility and the most suitable layout was chosen. Bord-and-pillar mining was then compared to conven-tional mining according to the following: financial analysis, dilution and flexibility.

get price

Optimization of Continuous Miner Operations in Bord and

Bord and pillar mining The following methods are commonly used in bord and pillar method for development and depillaring using continuous miner: Development 1. Bord and pillar method Depillaring 1. Split and Fender system 2. Nevid method of mining Continuous miner A continuous miner is a large steel drum equipped with a

get price

Design of Bord and Pillar method in coal mines

After pillar have been on bord and pillar system, has to be given to die extraction of mall from the prams; the operation is known as pmar . It Is referred to as depillaring or broken. One of the oldest method of mining is Bord and Pillar.

get price

EVALUATION OF BORD AND PILLAR MINING SYSTEM IN MCL

The success of Bord and Pillar mining is selecting the optimum pillar size. If the pillars are too large, then the extraction ratio decrease leading to less production and profitability and if the pillars are too small it becomes venerable to human safety. The issues relating to the stability of pillars

get price

Toward Pillar Design to Prevent Collapse of Room-and

Room-and-pillar mining accounts for a significant portion of the total mineral production in the United States As shown in table 1, well in excess of $6 billion worth of mineral commodities are produced each year by this method. A substantial portion ($3.55 billion) of coal production still comes from room-and-pillar mining. Metallic minerals

get price

Room and pillar mining

Room and pillar (variant of breast stoping), is a mining system in which the mined material is extracted across a horizontal plane, creating horizontal arrays of rooms and pillars. To do this, "rooms" of ore are dug out while "pillars" of untouched material are left to support the roof overburden. Calculating the size, shape, and position of pillars is a complicated procedure, and is an area of active research. The technique is usually used for relatively flat-lying deposits, such as those that follow a particular stratum.

get price

Bord and Pillar Method, Mine Ventilation, by OcS (www

May 08, 2013 This video is a chapter in the e-learning course offered by Octave Simulation Services Pvt. Ltd. (ocatvesim) on Mine Ventilation Systems. Contact tea...

get price

EVALUATION OF BORD AND PILLAR MINING SYSTEM IN

The success of Bord and Pillar mining is selecting the optimum pillar size. If the pillars are too large, then the extraction ratio decrease leading to less production and profitability and if the pillars are too small it becomes venerable to human safety. The issues relating to the stability of pillars

get price

Bord-and-pillar Definition of Bord-and-pillar by Merriam

Bord-and-pillar definition is of or relating to a system of coal mining in which tunnels are driven in a checkerboard pattern having massive square pillars between them

get price

Background review Subsidence from coal mining activities

techniques. ‘Bord and pillar’ is the oldest coal mining technique used in Australia and was common in New South Wales prior to about 1960. Originally it was the sole method used to extract all coal, but now it is generally used as the precursor to longwall mining to

get price

Room-and-pillar mining coal mining Britannica

Other articles where Room-and-pillar mining is discussed: mining: Room-and-pillar mining: The most common mining system is room-and-pillar. In this system a series of parallel drifts are driven, with connections made between these drifts at regular intervals. When the distance between connecting drifts is the same as that between the parallel drifts, then a

get price

Pillar design in coal mines

of bOld-and-pillar mining methods are widened to a coal-to-waste ratio of 1:5 and 40 per cent lost coal, then almost 63 per cent of the country's coal reserves fall within the scope of bord-and-pillar mining. From the above discussion it follows that considerable benefit can be

get price

DESIGN OF SUPPORT SYSTEM FOR BORD AND PILLAR

This is to certify that the thesis entitled, ―Design of support system for bord and pillar workings‖ submitted by Mr. Manoj Kumar Biswal in partial fulfillment of the requirement for the award of Bachelor of Technology Degree in Mining Engineering at the National Institute of

get price

Bord and Pillar mining method, Definition, Working, PDF in

Jun 21, 2020 Bord and Pillar Explanation. इस पोस्ट में हमने bord and pillar mining method definition, working Process, diagram इन सभी का PDF यह सभी जानकारी bord and pillar in hindi भाषा में इसके अलावा bord and pillar development, depillaring, advantages and

get price

EVALUATION OF PILLAR DESIGN SYSTEMS FOR LOW REEF

Aug 10, 2015 The success of a bord and pillar mining method in the exploitation of platinum heavily depends on a comprehensive and competent pillar design method. Pillars need to be large enough to contain load and to be small enough to avoid loss of resource. An optimum pillar design method achieves such a scenario.

get price

Pillar design in coal mines SlideShare

May 06, 2011 Cascading Pillar Failure (CPF) CPF is a potential problem faced by all Bord-and-pillar mining operations. CPF occurs when one pillar fails suddenly, which then overstresses the neighboring pillars, causing them to fail in very rapid succession. Within seconds, very large mining areas can collapse while giving little or no warning.

get price

Major Mines & Projects Chain Valley Mine

Since commencement of mining in the 1960’s, CVC has been utilising bord and pillar methods with full and partial pillar extraction as the primary means of secondary coal extraction. At the end of 2010 it was decided to change the primary extraction method to miniwall mining. Miniwall extraction commenced in September 2011.

get price

Research Report on the Coal Pillar Recovery under Deep

University (WVU), a study of the recovery of coal pillars through retreat room-and-pillar mining practices in underground coal mines at depths greater than 1,500 ft. The study should examine the safety implications of retreat room-and-pillar mining practices, with emphasis on the impact of full or partial pillar extraction mining.

get price

Can bord and pillar fly in Australia? MiningMonthly

Oct 13, 2006 THE bord and pillar method is widely used for coal production in South Africa and has developed in efficiency and productivity in recent years. Mining Consultancy Services managing director of Australia Chris Wilkinson says a review of underground mining practices could find bord and pillar conducive to Australian conditions.

get price

OPTIMIZATION OF MECHANIZED MINING LAYOUT

• Bord and pillar (1.8 m–2.2 m stope widths using low-profile (LP) mechanized equipment) • Breast mining (1.3 m stope width using extra-low profile (XLP) mechanized equipment) A graphical representation of the bord and pillar and mechanized breast mining methods is shown in Figure 1 and Figure 2. It is important to note that the

get price

89.pdf Coal mining Coal mining Coal mining is

In deep mining, the room and pillar or bord and pillar method progresses along the seam, while pillars and timber are left standing to support the mine roof. Once room and pillar mines have been developed to a stopping point (limited by geology, ventilation, or economics), a supplementary version of room and pillar mining, termed second mining

get price

Room and pillar mines, Mining Techniques, Underground

Room and pillar. Room and pillar is also known as bord and pillar is a mining system in which the mined material is taken out across a horizontal plane while leaving "pillars" of unscathed material to support the overstrain leaving open regions or "rooms" underground. It is normally utilized for fairly flat-lying deposits, like those that

get price

Room-and-pillar mining coal mining Britannica

Other articles where Room-and-pillar mining is discussed: mining: Room-and-pillar mining: The most common mining system is room-and-pillar. In this system a series of parallel drifts are driven, with connections made between these drifts at regular intervals. When the distance between connecting drifts is the same as that between the parallel drifts, then a

get price

Hard-rock room and pillar QueensMineDesignWiki

Room and pillar is an underground mining method that has applications to a wide variety of hard-rock deposits worldwide. It is commonly classified as an open-stoping method, meaning that development involves mining out underground cavities while leaving the

get price

What Is a Room and Pillar? (with picture)

Room and pillar mining may also be known as bord and pillar mining in some areas. Throughout history, miners have used a random room and pillar mining strategy to extract minerals from the earth. Workers would simply mine in certain areas and leave other areas intact, with little planning or reason involved in the process.

get price

DESIGN OF SUPPORT SYSTEM FOR BORD AND PILLAR

This is to certify that the thesis entitled, ―Design of support system for bord and pillar workings‖ submitted by Mr. Manoj Kumar Biswal in partial fulfillment of the requirement for the award of Bachelor of Technology Degree in Mining Engineering at the National Institute of

get price

Background review Subsidence from coal mining activities

techniques. ‘Bord and pillar’ is the oldest coal mining technique used in Australia and was common in New South Wales prior to about 1960. Originally it was the sole method used to extract all coal, but now it is generally used as the precursor to longwall mining to

get price

Hard-rock room and pillar mining best practice industry

pillar mining a series of parallel drifts are driven, with connections made between these drifts at regular intervals. When the distance between connecting drifts is the same as that between the parallel drifts then a checkerboard pattern of rooms and pillars is created. The pillars of ore are left to

get price

EVALUATION OF PILLAR DESIGN SYSTEMS FOR LOW REEF

Aug 10, 2015 The success of a bord and pillar mining method in the exploitation of platinum heavily depends on a comprehensive and competent pillar design method. Pillars need to be large enough to contain load and to be small enough to avoid loss of resource. An optimum pillar design method achieves such a scenario.

get price

The design of stable pillars in the Bushveld

regarding pillar strength and loading stiffness, monitoring in trial mining sections and in established mining areas is also an essential tool to test the stability of pillar layouts in particular geotechnical areas. Keywords pillar design, bord and pillar mining, stable pillars. * Department of Mining

get price

Depillaring: Arrangement, Precautions and Pillar

General, a pillar greater in size than 18 m x 18 Tm is split up into two stooks. In a large pillar of 30 m x 30 m size between centres, one split 3.5 m wide in the middle of the pillar along the strike and another split of similar width in the middle of the pillar along the dip, are driven so that the pillar

get price

bord & pillar miners Archives International Mining

Jun 02, 2021 Mastermyne will provide underground mining equipment from its current fleet, including three bord & pillar miners, multi bolters and shuttle cars along with a range of ancillary production equipment to support the operation. The contract is expected to deliver on average A$80-100 million of revenue per year once in full production, Mastermyne says.

get price

Mining Funda: Bord and Pillar method of Mining

Nov 21, 2019 The bord and pillar mining can be done in three ways, namely:-. Develop the entire area into pillars and then extract the pillars starting from the boundary. Develop the area into panels and extract pillars subsequently panel-wise. This is called as panel system of mining. "Whole" followed by "Broken" working in which the mines is opened out by

get price

Major Mines & Projects Rustenburg Operation

Mining Methods. Breast mining. Bord-and-pillar. Hydraulic mining. Summary: Rustenburg consists of three intermediate depth operating vertical shafts, which utilise a conventional mining method (Siphumelele 1, Khuseleka 1 and Thembelani 1) and Bathopele, which is a shallow mechanised operation. The Mineral Resource is accessed from surface using

get price

Two Rivers Platinum Mine: the orebody, the mining

The mining method is a mechanized bord and pillar layout, which will yield a total of 185 000 tons at full run of mine production from the underground UG2 mine. 152 PLATINUM SURGES AHEAD An average dip of 8 degrees has been recorded from underground development and mining, which compares

get price

Booking Online

#